FablabSU

Ceci est une ancienne révision du document !

---

#include <Wire.h> #include <M5Stack.h> #include <VL53L1X.h>

VL53L1X sensor;

void setup() {

Serial.begin(115200);
Wire.begin();
Wire.setClock(400000); // use 400 kHz I2C
M5.begin();

sensor.setTimeout(500);
if (!sensor.init())
{
  Serial.println("Failed to detect and initialize sensor!");
  while (1);
}

sensor.setDistanceMode(VL53L1X::Long);
sensor.setMeasurementTimingBudget(15000);
sensor.startContinuous(15);
Serial.println("new program");

}

void loop() {

Serial.println(String(millis())+","+String(sensor.read()));
M5.Lcd.print(String(millis())+","+String(sensor.read()));

}

#include <M5Stack.h>; #include “BluetoothSerial.h”; BluetoothSerial SerialBT; int trig = 2; int echo = 5; long lecture_echo; long cm; void setup(){ SerialBT.begin(“M5Stack”); M5.begin(); M5.Power.begin(); pinMode(trig, OUTPUT); digitalWrite(trig, LOW); pinMode(echo, INPUT); Serial.begin(9600); M5.Lcd.print(“Bienvenue sur les tutoriels d'IHM 3D”); M5.Lcd.print(cm); } void loop(){ digitalWrite(trig, HIGH); delayMicroseconds(10); digitalWrite(trig, LOW); lecture_echo = pulseIn(echo,HIGH); cm = lecture_echo /58; M5.Lcd.print(“Distance en cm :”); M5.Lcd.println(cm); SerialBT.println(cm); delay(1500); }