FablabSU

Ceci est une ancienne révision du document !

---

/* === Project-universal Constants === */

Not all of these variables are used in this specific model, but the same variable set is used across all models in this project.

$fs = 0.1;

inch = 25.4; for mm conversion width of base baseSizeY = 2*inch; centerY = baseSizeY / 2; both axes go right down the middle of the base stepper motor stepperZSize = 42; stepperYSize = 42;

608 bearing bearing608Height = 8.5; bearing608Diameter = 22.5; height of holder for 80/20 screws mountPlateHeight = 5;

axis heights threadedAxisHeight = stepperZSize/2 + mountPlateHeight + 4; smoothAxisHeight = (threadedAxisHeight-6.6) / 2; smoothRodRadius = 4.2; syringe properties barrelDiameter = 25;

barrelSlotThickness = 3; barrelSlotHeight = 28;

syringeCenterHeight = threadedAxisHeight + bearing608Diameter/2 + 4 + barrelDiameter/2;

fixes render oddities floatCorrection = 0.001; floatCorrection2 = 2*floatCorrection; 8020 mounting plate screwPlateSize = 25; screwRadius = 3.5;